Cold Rolled Carbon Steel for automotive use

Specification Chemical Composition
 (% Maximum)
Value Max Hardness Rb Min Yield point Mpa Min Tensile 
Mpa
Min Elongation % (2") Description and typical applications
C Mn P S Al Mín. r n
ASTM A-366 0.020 - 0.15 0.60 0.030 0.035 - - - 60 - - - Commercial forautomotive parts that do not require high drawnability.
ASTM A-619-97 (1) 0.10 0.50 0.020 0.030   1.0 - 1.5 0.17 - 0.21 55 172 - 275 - 32 (1) Deep drawing for carriage exterior parts.
ASTM A-620 (1)  0.08 0.50 0.020 0.030 0.01 1.3 - 1.7 0.17 - 0.22 50 151 - 241 (1) - 36 (1) Extra deep drawing for carriage exterior parts.
ASTM A-1008 CS(1) 0.02 - 0.15 0.60 0.030 0.035 - - - - - - - Commercial for automotive parts that do not require high drawnability.
ASTM A-1008 DS(1) 0.02 - 0.08 0.50 0.020 0.030 0.02 1.30 - 1.70 0.17 - 0.22 - 150 - 240 - 36

Commercial for automotive parts that do not require high drawnability.

EN 10130 FeP01 0.12 0.60 0.045 0.045 - - - - 140 - 280 270 - 410 28 (80 mm) Commercial for automotive parts that do not require high drawnability.
EN 10130 FeP03 0.10 0.45 0.035 0.035 - 1.3 - - 140 - 240 270 - 370 34 (80 mm) Deep drawing for carriage exterior parts.
EN 10130 FeP04 0.08 0.40 0.030 0.030 - 1.6 0.18 - 140 - 210 270 - 350 38 (80 mm) Extra deep drawing for carriage exterior parts.
JIS G 3141 SPCC 0.12 0.50 0.040 0.045 - - - 60 - 270 mín 34 (2) Commercial for automotive parts that do not require high drawnability.
JIS G 3141 SPCD 0.10 0.45 0.035 0.035 - - - 55 - 270 mín 36 (2) Deep drawing for carriage exterior parts.
JIS G 3141 SPCE 0.08 0.40 0.030 0.030 - - - 50 - 270 mín 38 (2) Extra deep drawing for carriage exterior parts.

(1) The values of the typical mechanical properties indicated, are not mandatory. 
(2) Depends on thickness, beaker JIS 5.